Goatnut
03-15-2005, 09:29 AM
I've been working on the '67 GTO and wondered if there were some tips anyone could offer. I replaced the "channel" weatherstripping at the leading edge of the door glass. This piece runs from the top of the vent window through to the bottom of the door. All of the disassembly was a breeze. But I had a real hard time getting both of the rollers for the window crank assembly to go back into the window.
I managed to get the drivers door completed and thought it was a good time to do some cruising. Now the job is only half done so I need to get at the other side. Any suggestions on how to simplyfy this job?
Scott
I managed to get the drivers door completed and thought it was a good time to do some cruising. Now the job is only half done so I need to get at the other side. Any suggestions on how to simplyfy this job?
Scott