Fresh 400 longblock.

[Pontiacshack]

This engine has just been reassembled with new bearings,rings and oil pump. The rods were shot peened and the whole bottom was balanced. It has forged pistons and a Pete Jackson gear drive (quiet) along with a holley fuel pump. The heads are 6x (4)s with new 7/16 studs,springs,retainers and keepers, matched to the cam, along with comp cams roller tip rockers (1.52). I'm not sure of the spec's on the cam, but I will try to find out and post it later. The engine also has a Milodon deep oil pan. It has a torker manifold and an A.E.D. holley 750 dp on it. It can be purchased with or without the carb and intake. The only thing it doesn't have is the distributor. It is ready to bolt in and go. The price you ask, 2000. firm without carb and manifold, or 2300. with. I firmly believe this engine will be good to go for along time to come.

[goatweed]

Hey... who did the rebuild on this engine and have you found out the spec`s on the cam? I am it the process of rebuilding my car and this may be easier than rebuilding my engine. :-/
Gary

[Pontiacshack]

This engine was built by Blake at Honest Performance. As far as the spec's on the cam, I haven't gotten them yet, but Blake said it was around a 505 lift. I will try to call Blake Monday and get them. You can call me at 253-862-6864, and I can give you the complete run down on the engine. Thanks. Stefan.

[Pontiacshack]

Okay folks, here's your chance to save some precious time, with Tiger run just around the corner, why take the time to do an engine rebuild. Here at the PONTIAC SHACK, we have just the engine for you, ( dang I should have been in sales). Guyle still has this engine, and may be willing to take just a few pennies less. ;D